COMPRO IP540 User Manual download pdf (Page 67)

9-1Re-conguring Your Device<頁頁頁頁頁頁>

Chapter 9: Troubleshooting

During the course of installation, you may encounter various issues in regard to the usage of either the

cameraortheComproView®software.Thefollowingsectioncontainssometroubleshootingproceduresto

help you solve the problems.

Re-conguring Your Device

Anytime you need to re-congure your IP camera, you can simply double-click on the iWizard icon (or tap

Start>Programs>ComproView®>iWizard)toopentheiWizardcongurationtool.Duringtheconguration,

the iWizard will automatically scan for all of the available Compro IP surveillance products installed on your

LAN network (even if they are not on the same subnet). The scanning generally takes around 1 minute to

complete, and once the scanning completes, you will see the available IP cameras populating the list.

Figure 9-1. Camera selection

Cabling Check

If you didn't see your IP camera on the connected device list in iWizard, go through the following steps to

check your cabling.

1. Check that the IP camera has been connected to the LAN network and has been powered on for over 1

minute.

2. Check if your computer has a successful connection to the network.

Computer is connected Computer is not connected

Table 9-1. Windows network connection

Note:

You can check the status of your router connection by

logging onto your router's maintenance page.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 89 90

No comments

COMPRO IP540 User Manual Page 67