COMPRO IP540 User Manual download pdf (Page 15)

3-1Connecting the Cables<頁頁頁頁頁頁>

Chapter 3: Installtion

Chapter 3: Installation

Connecting the Cables

The picture below shows the basic connection of your IP camera.

Figure 3-1. Connection of cables

LAN cable from PC to hub/router: If your LAN cable from PC has been connected to the Cable/ADSL

modem, please re-connect it to the Ethernet port of your hub/router.

Ethernet port on camera: Use the bundled RJ-45 LAN cable to connect the Ethernet port of the IP

camera to the Ethernet port of your hub/router.

Wireless adaptor (Optional accessory): If you have purchased the Compro USB wireless adaptor for

wireless connection, please plug it into the USB port of IP camera for wireless reception.

Power: Attach the power adapter to the camera’s power connector and connect the power plug to a

power outlet.

Caution!

• ThewirelessconnectionportonlysupportstheComprowireless

adaptors;pleasedonotuseotherUSBadaptersonComproIPcamera.

Should you remove the wireless adaptor during camera operation,

you need to power o the camera rst before re-plugging it.

• PleasedonotrotateyourIPcamerabyhand.Itmaycausethedamage

of the IP camera.

• Whenyouunplugthepowerplugfromthewalloutletwhilethe

camera is still in operation, wait for 4 seconds before plugging the

power plug back in the wall outlet. And avoid too frequent plugging

and unplugging of power cable.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 89 90

No comments

COMPRO IP540 User Manual Page 15